References / Glass

3B Fibreglass · 2025

Industrial site water diagnostic

What a full water diagnostic reveals about an industrial site

Sector
Glass fibre manufacturing
Scope
Audit & diagnostic
Location
Herve, Belgique

The challenge

Water on an industrial site is rarely a single subject. It cools, it conditions air, it cleans, it goes into process solutions. Every use has its own quality requirement, its own cost and its own discharge. After years of successive investments, the whole picture becomes hard to hold in one view.

That overall view is what 3B Fibreglass, a manufacturer of reinforcement glass fibre, set out to give itself. A site supplied from the public network, in a region where the price of water is rising and where discharge regulation is tightening, needed to know where its water goes, what alternatives exist, and in what order to act.

Without a shared map, every improvement idea stays an intuition that cannot be weighed against another.

Our approach

Start from the site's exposure, not its equipment

A water diagnostic starts upstream of the plant. Do run-off concentration axes cross the site? Is it exposed to drought episodes that could constrain its supply? These two questions determine the resilience of the production asset long before any treatment technology is chosen.

Match every use to the water quality it actually requires

An industrial site does not consume "water": it consumes several water qualities, produced and distributed separately. The diagnostic traces every use back to the quality feeding it, then asks the question that opens up substitutions: does this use actually need that quality?

This is the heart of the exercise. A circuit fed with potable water that would accept recycled water, a make-up stream that could be covered by a concentrate rather than the network: these gaps between the quality supplied and the quality required are where the reductions sit.

Inventory every source, not just the one in use

Public network, surface water, groundwater, rainwater, recycled effluent: each resource is assessed for availability, quality and regulatory feasibility. Some are ruled out at this stage, and that is useful: knowing an option does not hold avoids returning to it.

For those that do hold, the diagnostic sets out what their implementation depends on: treatment capacity to extend, a permit to obtain, a quality compatibility to verify.

Treat discharge as half the subject

A diagnostic that stops at supply misses half the cost. Discharge points, environmental permit limits, the applicable sanitation regime and the related taxation are all part of the same balance.

To which the question of emerging pollutants must be added, as it shifts the frame: it is addressed by identifying the origin, mapping the extent, then choosing between concentration, adsorption and destruction. That choice calls for testing, not a technology preference.

Rank rather than list

A diagnostic that delivers twenty flat recommendations does not help anyone decide. The deliverable ranks the options by investment and expected impact, separating those needing only an operational effort from those implying a capital project.

That grading is what makes the document usable in a steering committee: it gives an order of march, not a catalogue of options.

Results

  • Site water cycle fully mapped

    From furnace and electrode cooling through to the three discharge points, via the three reverse osmosis units, the SBR treatment plant and ultrafiltration.

  • Rainwater potential quantified at 8% of annual consumption

    27,160 m³/year recoverable from 35,000 m² of flat roof at an 80% recovery rate, today routed to the treatment plant and then to the sewer.

  • Groundwater resource identified as exploitable

    The Crétacé du Pays de Herve aquifer, currently unexploited, with no immediate regulatory obstacle identified.

  • PFOA contamination quantified and placed on the action plan

    Concentration measured at discharge, with a recommendation for an in-depth study including pilot-scale adsorption testing.

  • Reduction in city water consumptionexpected

    Expected, not yet achieved. The levers are quantified but their implementation depends on the site's internal smart monitoring project, due to go live at the end of 2026.

Impact

3B Fibreglass now has a shared map of its water cycle, an inventory of alternative resources with their feasibility conditions, a ranked action plan and a route on the question of emerging pollutants.

A diagnostic does not replace metering, and that should be said plainly: quantifying a saving requires measurement. What the diagnostic brings is knowing where to place the meters and what to expect from them, enough to turn a measurement campaign into decisions rather than data.

We do not manufacture equipment. That is what lets us recommend the solution best suited to a site, and rule an option out without losing anything by it.

Partners

  • Cebedeau — outlet water analyses and microscopy

Talk to our engineers